Home / Tile Floors / tiling a bathroom floor around a toilet / Floor Tiles For Bathroom Tile Designs Awesome Floors Archaicawful Tips Choose Ceramic Pattern Tiling Around Toilet Chooseic Ideas Modern And Choosing Inspiring Design
ggpk Tile Floors July 25th, 2018 - 08:16:30
If a subfloor displays excessive deflection. it can usually be remedied by installing more plywood on top of it before tile is laid. and by reinforcing the joists from below. While it may make the floor higher than before. think of it as a sort of `insurance policy` against flooring failure.
Prepare the Sub-Floor for the Tiling Process. After you are ready with your tools and before you begin tile flooring installation. you must first prepare the sub-floor for the ceramic tile flooring installation. This involves cleaning the sub-floor thoroughly and checking it for cracks. If you do find cracks. you must repair them. If any crack is too large to repair. that section of the floor must be replaced completely. If your floors are wooden make sure that they are supported well and are at least two inches thick so that they are able to withstand the weight of the tiles you are about to install on them. Once you have checked for cracks and cleaned all the debris off the sub-floor you are ready to begin with your ceramic tile flooring installation.
Glazed and Unglazed Tiles. Firstly. there are glazed and unglazed tiles; the glazed tiles can be cleaned very easily and do not stain as often as unglazed tiles. All you need to do is run a mop soaked in warm water with a mild detergent solution across them from time to time. The problem with glazed tiles is that they are very smooth and therefore can be quite slippery. This is dangerous. especially if the kitchen area is prone to water spillage or if there are young children in your home. To avoid this. you could choose unglazed tiles over glazed ones. Unglazed tiles will prevent the floor from being slippery and have an aesthetically pleasing textured surface. Then again. unglazed tiles will not be as durable as glazed ones - they will be relatively more prone to damage because they are not protected by that extra layer of glazing.
Can you cut into the layers on top to get a cross section of the existing floor? If there is a heating grate that you can remove. that may show the layers the floor is composed of. What will be reassuring to see is a thick layer. ideally over 1 ½ inches thick of plywood. Alternatively. with the property owner`s permission. we sometimes cut in to it to check what it`s composed of.