Home / Tile Floors / porcelain tile that looks like hardwood flooring / Porcelain Tile That Looks Like Wood Reviews Shower What Size Grout Line For Bathroom Hardwood Flooring Lowes Grain Home Depot Pros And Cons Floor Look Planks Oak
ggpk Tile Floors July 09th, 2018 - 18:08:52
First. you have porcelain tiles. These tiles are made by firing at high temperatures. They are also very dense and moisture resistant. You can purchase porcelain in a variety of shades and colors. Porcelain tiles are the most expensive though but with them you have tile flooring ideas that can mimic stone and other materials.
Glazed and Unglazed Tiles. Firstly. there are glazed and unglazed tiles; the glazed tiles can be cleaned very easily and do not stain as often as unglazed tiles. All you need to do is run a mop soaked in warm water with a mild detergent solution across them from time to time. The problem with glazed tiles is that they are very smooth and therefore can be quite slippery. This is dangerous. especially if the kitchen area is prone to water spillage or if there are young children in your home. To avoid this. you could choose unglazed tiles over glazed ones. Unglazed tiles will prevent the floor from being slippery and have an aesthetically pleasing textured surface. Then again. unglazed tiles will not be as durable as glazed ones - they will be relatively more prone to damage because they are not protected by that extra layer of glazing.
What floor covering was on the floor before? If it had ceramic tile or stone. and the floor received reasonable traffic for years with no cracking or broken grout. it`s a pretty good bet that the subfloor is up to the job. If it was vinyl. carpet or hardwood. we are still in the dark.
There are formulas used in the industry to determine if the subfloor has excessive `deflection` [bounciness. lack of rigidity]. The most cited one is the Tile Council of North America standard for deflection. which is stated as L/360 as a minimum. before tile underlayment is installed. L/360 means that the floor should not bend under weight more than the length (expressed in inches) of the unsupported span divided by 360. For example. if the span between supports runs for 20 feet then the deflection should not be more than 2/3" between the center and the end. L=20 x 12" = 240". L/360 = 240"/360 or 2/3". So 2/3" is the maximum amount of movement the center of the span should be allowed to move.