Home / Tile Floors / porcelain tile that looks like hardwood flooring / Laminate Flooring Hardwood Prices Floor Refinishing Wood Look Tile Cost Porcelain That Looks Like Engineered Tiles Grey Floors Bathroom Wall Planks Ceramic Plank White
ggpk Tile Floors July 09th, 2018 - 18:07:53
How thick is the subfloor and what is it made of? In new construction. ¾ inch plywood or Oriented Strand Board is a standard subfloor over joists that are 16 inches on center apart. We find that is almost never enough to meet the deflection standards in most homes. Other times there is old plank flooring beneath a layer of plywood. This is a wild card. since the engineering tables usually don`t include the value for planks in their calculation. but common sense says it does add some stiffness.
Measure Everything. The next step of your ceramic tile flooring installation is the accurate measuring of your floor and your tiles. This is necessary for you to be able to calculate exactly how many tiles you will need. You must measure the length and width of the section of floor you are going to tile and also the length and width of each tile. Then you must calculate. using these numbers. exactly how many tiles you are going to use. which will depend on the orientation of each tile as you have decided to place it on the floor. as well. Then you must find the mid-points of the length and the width of the floor you want to carry out your ceramic tile flooring installation process on; connect these midpoints to form a plus across the floor space. The intersection of the two lines of the plus is the center of your floor space; it is here that you must begin your ceramic tile flooring installation.
If a subfloor displays excessive deflection. it can usually be remedied by installing more plywood on top of it before tile is laid. and by reinforcing the joists from below. While it may make the floor higher than before. think of it as a sort of `insurance policy` against flooring failure.
What condition does the wood appear to be in? Even if the amount of wood support seems adequate according to the tables. if it appears to have been water damaged. if sections of it look moldy or corroded due to rot or decay. it`s not doing its job. Options include replacing or reinforcing it. but not just ignoring it. Also. has it been cut into in various spots. such as a plumber cutting sections of the joists for positioning pipes? All of these problems can make the wood less effective.