ggpk Tile Floors July 25th, 2018 - 09:09:27
For plywood subfloors. be sure that the wood is at least 1 and 1/8 inches thick and is supported by an equally strong underlayment. Otherwise. your ceramic tiles will dislodge easily. or worse. break and need replacing. Concrete floors are the most ideal subfloor surface to work with. But before you can start installing ceramic tile flooring over it. it must be cleaned thoroughly. For dust and other debris. sweep and then mop your concrete subfloor surface. and allow it to dry completely. Smooth concrete surfaces must be rough sanded just like vinyl floors to allow the tiling mortar some grip.
Can you cut into the layers on top to get a cross section of the existing floor? If there is a heating grate that you can remove. that may show the layers the floor is composed of. What will be reassuring to see is a thick layer. ideally over 1 ½ inches thick of plywood. Alternatively. with the property owner`s permission. we sometimes cut in to it to check what it`s composed of.
What`s the property owner`s risk tolerance? Does he/she want to be rock solid sure of the stability of the floor? Even if that means spending extra money and/or time to reinforce the floor. and accepting a floor that may sit higher than surrounding floors? Or is some risk of failure acceptable if the floor is not built to the righteous standards of the TCNA? Sometimes the extra effort is not worth the cost to the property owner. who should be fully informed on all options. Contractors who install flooring shouldn`t assume that clients don`t care enough to solve the problem: in the last year we`ve had two clients who spend thousands of extra dollars to reinforce subfloors in a kitchen and laundry room when we explained that their floors were too unstable for tile. They really wanted tile. and were willing to make the subfloor ready for it. even if it cost more.
Install the Ceramic Tiles. Start with the center and move outwards with each ceramic tile. Use thin set mortar or tile adhesive to set the tiles. make sure that the bond between the tile and the sub-floor sets by applying pressure on each tile. After the tiles have set. complete the process by applying the grout. Remember that the grout must be of the same color as the tiles you have chosen. Remember that each step requires twenty-four hours to set and dry before allowing yourself to proceed to the next step of your ceramic tile flooring installation.