Home / Tile Floors / ceramic tile flooring that looks like wood planks / Floor Design Gorgeous Home Interior Decoration Ideas Using Light Oak Wood Vinyl Flooring That Looks Like Ceramic Tile Along With Cream Wall And Wooden Sheraton Table
ggpk Tile Floors July 09th, 2018 - 17:51:20
Prepare the Sub-Floor for the Tiling Process. After you are ready with your tools and before you begin tile flooring installation. you must first prepare the sub-floor for the ceramic tile flooring installation. This involves cleaning the sub-floor thoroughly and checking it for cracks. If you do find cracks. you must repair them. If any crack is too large to repair. that section of the floor must be replaced completely. If your floors are wooden make sure that they are supported well and are at least two inches thick so that they are able to withstand the weight of the tiles you are about to install on them. Once you have checked for cracks and cleaned all the debris off the sub-floor you are ready to begin with your ceramic tile flooring installation.
Can you cut into the layers on top to get a cross section of the existing floor? If there is a heating grate that you can remove. that may show the layers the floor is composed of. What will be reassuring to see is a thick layer. ideally over 1 ½ inches thick of plywood. Alternatively. with the property owner`s permission. we sometimes cut in to it to check what it`s composed of.
Measure Everything. The next step of your ceramic tile flooring installation is the accurate measuring of your floor and your tiles. This is necessary for you to be able to calculate exactly how many tiles you will need. You must measure the length and width of the section of floor you are going to tile and also the length and width of each tile. Then you must calculate. using these numbers. exactly how many tiles you are going to use. which will depend on the orientation of each tile as you have decided to place it on the floor. as well. Then you must find the mid-points of the length and the width of the floor you want to carry out your ceramic tile flooring installation process on; connect these midpoints to form a plus across the floor space. The intersection of the two lines of the plus is the center of your floor space; it is here that you must begin your ceramic tile flooring installation.
Fine. but how do you know if your floor meets the L/360 standard? We face this in the field all the time. but in remodeling. there`s not always a clear answer. There are published tables for calculating deflection. (including a really cool online calculator at http://www.johnbridge.com/vbulletin/deflecto.pl ) but they assume you have full knowledge of how the floor was built. To be able to use the engineering tables. you`d need to know how far apart the joists are. the length of the unsupported span. how thick the joists are. what type of wood and in what condition the wood is in. as well as how thick the plywood is. if any. Realistically. if all of this flooring is hidden by finished ceilings below and covered over by old flooring layers above. educated guessing takes center stage. The following questions help to determine floor stiffness using common sense guidelines