Home / Tile Floors / black and white ceramic floor tile patterns / Luxury Black White Marble Flooring For Kitchen Design Showcasing Sculptural Legs Dining Table With Top Teamed Industrial Lighting Fixture Ideas Tile Designs Floors Boas
ggpk Tile Floors July 14th, 2018 - 08:07:40
You also have ceramic tiles. This kind of tile is the inexpensive way to achieve the look of granite or marble floors. They can give the effect of having water on your floors that`s oh so dramatic. Another kind of tile you can use as flooring is metal tile. These are either industrial gratings or stainless steel. If you want your floor to have the look of brass. bronze or steel. this is the one to go for. You can mix and match this tile with other kinds of tiles to accent the floor and create a point of interest in the room.
Is there an unfinished ceiling below to look up and measure the distance between joists and the condition of the wood below and how long the unsupported span is? A few minutes in the basement with a flashlight and tape measure can let you know if you have a winner (thick and deep joists. spaced closely together. in good condition. with a narrow span). or a loser (thin and shallow joists. irregularly spaced or spaced far apart. in bad condition. with a long span).
Ceramic Tile Flooring - Remodeling Over Wood Subfloors. Before you can install a ceramic tile or stone floor. you need to know if the subfloor is even capable of supporting tile. Simply put. tile can be a durable. low maintenance. beautiful floor choice...if it`s on a solid substrate. Or it can be an expensive mistake that cracks. breaks and requires multiple repairs that may never work if the subfloor is not prepared correctly. What factors do you need to look out for to decide if tile is right for your project. and what steps can be taken to insure a trouble free installation?
How thick is the subfloor and what is it made of? In new construction. ¾ inch plywood or Oriented Strand Board is a standard subfloor over joists that are 16 inches on center apart. We find that is almost never enough to meet the deflection standards in most homes. Other times there is old plank flooring beneath a layer of plywood. This is a wild card. since the engineering tables usually don`t include the value for planks in their calculation. but common sense says it does add some stiffness.