ggpk Tile Floors July 11th, 2018 - 18:56:04
Prepare the Sub-Floor for the Tiling Process. After you are ready with your tools and before you begin tile flooring installation. you must first prepare the sub-floor for the ceramic tile flooring installation. This involves cleaning the sub-floor thoroughly and checking it for cracks. If you do find cracks. you must repair them. If any crack is too large to repair. that section of the floor must be replaced completely. If your floors are wooden make sure that they are supported well and are at least two inches thick so that they are able to withstand the weight of the tiles you are about to install on them. Once you have checked for cracks and cleaned all the debris off the sub-floor you are ready to begin with your ceramic tile flooring installation.
Is there an unfinished ceiling below to look up and measure the distance between joists and the condition of the wood below and how long the unsupported span is? A few minutes in the basement with a flashlight and tape measure can let you know if you have a winner (thick and deep joists. spaced closely together. in good condition. with a narrow span). or a loser (thin and shallow joists. irregularly spaced or spaced far apart. in bad condition. with a long span).
How tough is the tile to be installed? Fairly thick quarry tiles. for example. may be rated for heavy duty industrial applications. although they are often installed in homes. Because they are thicker than normal tiles and able to withstand heavy traffic. they may be less prone to cracking than a sensitive. thinner tile. For that matter. natural stone such as marble and granite are on the other end of the spectrum - they crack even easier than ceramic tile and should not be used in settings where any excess deflection is possible. Intuition may tell you they are stronger than ceramic. but in fact they are more brittle and prone to cracking. They need twice as rigid a floor as ceramic.
What condition does the wood appear to be in? Even if the amount of wood support seems adequate according to the tables. if it appears to have been water damaged. if sections of it look moldy or corroded due to rot or decay. it`s not doing its job. Options include replacing or reinforcing it. but not just ignoring it. Also. has it been cut into in various spots. such as a plumber cutting sections of the joists for positioning pipes? All of these problems can make the wood less effective.